6.
If the registration is successful, the base unit IN USE LED will blink and the
handset will emit three beep tones and the LCD Display shows SYSTEM
UPDATE.
B. REGISTERING NEW HANDSET TO EXISTING REGISTERED HANDSET
Additional handset can be registered on the base unit (same as the above
procedure) or it can be registered on the existing first registered handset.
1.
In standby mode, press the new handset's MENU button.
2.
Press new handset's UP or DOWN button to search for "REGISTER REQ."
(Register Request).
3.
Press new handset's OK button to select. The LCD Display shows HS NO:.
4.
Enter the desired handset number and press OK button to confirm.
5.
When the LCD Display shows WAIT REG CONF, press the existing
registered handset's MENU button. The waiting time for registration
confirmation is 10 seconds.
6.
Press the existing registered handset's UP or DOWN button to search for
"ALLOW REGISTER".
7.
Press the existing registered handset's OK button to select the handset to
handset registration.
8.
If the registration is successful, the handset will emit three beep tones.
TONE / PULSE SETTING
Select the appropriate dialing service by moving the
T / P (Tone / Pulse) switch on the bottom of the base unit: . T / P
T (TONE) for Tone service, or (Figure 10)
P (PULSE) for Rotary service
SETTING THE HANDSET RINGER ON / OFF MODE
The handset ringer must be set to ring ON (DND OFF) mode in order to ring when
receiving an incoming call. See PROGRAMMING MENU section on page 24.
NOTE:
The default mode is ring ON (DND OFF) mode.
SETTING HOME AREA CODE AND LOCAL AREA CODE
In order to use callback function, the home (user's) area code and local
(neighboring) area code must be programmed. See PROGRAMMING MENU
section on page 27.
ENABLING THE AREA CODE FUNCTION
To enable the auto area code matching, the Area Code Function must be enabled.
See PROGRAMMING MENU section on page 28.
13
02252A-1
36570/02252A-1.PUT
5/26/01, 11:35 AM
14
