Manual Operation
This is done by operating the switches located at the top right hand side of the fire .The
standby rocker switch must first be switched on, the fire will beep to indicate that it is
powered up.
Press the O/I button once to turn on the appliance and fire effect. A red indicator light will
show to indicate that the fire is ON. Press the O/I button for 3 seconds this will operate the
dimmer mode, hold the button down until the desired brightness is obtained.
Press the 750W button once for the low heat setting; press twice to switch off the heat
setting.
Press the 1500W button once for the high heat setting; press twice to switch off the heat
setting.
Remote Operation
The standby rocker switch located at the top right hand side of the fire must first be
switched on; the fire will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not press the buttons
more than once within two seconds for the fire to operate normally.
Press the ON/OFF button once to turn on the appliance and fire effect.
Press the 750W button once for the low heat setting; press twice to switch off the heat
setting.
Press the 1500W button once for the high heat setting; press twice to switch off the heat
setting.
Press the DIMMER button to operate the dimmer mode, repeat pressing will raise and
lower the brightness.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g. due
to blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect to the mains supply and switch on the appliance.
Troubleshooting
Symptom
Solution
No operation/ no fan.
Check fuse by replacement.
Check for safety cut-off operation.
No fire effect light.
Check the bulb by replacement.
Replacing the Lamp
Warning- Always disconnect from the power supply before replacing the bulbs.
Warning- The bulbs will reach a high temperature during operation.
Allow the bulbs to cool down after switching off the appliance before replacing.
NOTE
: Two people will be required for this process.
Содержание EF451S
Страница 2: ......
