12
FLAME +
FLAME “+”
: Makes flame effect brighter.
NOTE:
Flame effect stays on until power
button is turned off. Flame effect must be
on for heater to turn on.
1.
Press once
. Flame effect gets brighter.
2.
Press again until desired setting is
reached
. Flame effect continues to get
brighter each time button is pressed.
HEATER
HEATER button
: Turns heater on and off.
NOTE:
The heater only works when the
flame effect is on. If the flame effect is off,
the heater will not turn on.
NOTE:
To prevent overheating, the heater
blows cool air for 10 seconds before the
heater turns on, and after it turns off.
1.
Press once
. Indicator lights up.
Fan blows cool air for 10 seconds. Low
heater turns on and blows warm air.
2.
Press again
. Indicator lights up.
High heater turns on and blows hot air.
3.
Press again.
Heaters turn off.
The fan blows cool air, then turns off.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.
NOTICE
To improve operation,
aim
the remote control at the front of the fireplace.
DO NOT
press the buttons too quickly
. Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature (212
F / 100
C), the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
This remote control uses
two AAA batteries (
Not included
).
Instructions for battery installation are on the Remote Control battery compartment.
NEVER
dispose of batteries in
re.
Failure to observe this precaution
may result in an
explosion
. Dispose of batteries at your local hazardous material processing center.
Care and Maintenance
Cleaning
Содержание 80-421S
Страница 6: ...6 C ...
Страница 9: ...9 Installation for Pebbles ...
