Installation & Quick Setup Guide
10
2
Installation
Before you start:
●
Make sure the device in the package is in good condi
ti
on and all
the assembly parts are included.
●
The standard power supply is 12V DC, please make
sure your power supply matches with your camera.
●
Make sure all the related equipment is power-o
ff
during the
installa
ti
on.
●
Check the speci
fi
ca
ti
on of the products for the installa
ti
on
environment.
●
Make sure that the wall is strong enough to withstand four
ti
mes the weight of the camera and the bracket.
For the camera that supports IR, you are required to pay a
tt
en
ti
on to
the following precau
ti
ons to prevent IR re
fl
ec
ti
on:
●
Dust or grease on the dome cover will cause IR re
fl
e
cti
on.
Please do not remove the dome cover
fi
lm un
ti
l the installa
ti
on
is
fi
nished. If there is dust or grease on the dome cover, clean
the dome cover with clean so
ft
cloth and isopropyl alcohol.
●
Make sure that there is no re
fl
ec
ti
ve surface too close to the
camera lens. The IR light from the camera may re
fl
ect back into
the lens causing re
fl
e
cti
on.
●
The foam ring around the lens must be seated
fl
ush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are a
tt
ached seamlessly.
