Northern Lights M65C13, Руководство оператора

Страница: 62 / 122

Lubrication&Maintenance/2000 Hour/24 Month
RG19661,0000401 -19-06MAR13-3/3
Install Impeller
1. Apply LOCTITE® 242 (Deere Part No. TY9370) to
curved side of cam plate near threaded hole and install
cam plate into impeller housing bore, be sure holes in
cam plate and housing are aligned. Apply LOCTITE® 242
to cam screw (B), install, and tighten.
The cam plate should be inspected to insure that none of
the cam fingers are protruding which could cause impeller
damage. The cam screw should also be inspected to
insure that it does not protrude below the cam plate.
Replace cam plate and cam screw or grind screw flush
as needed.
IMPORTANT: Petroleum based lubricants can cause
the impeller to swell, and are not recommended
to lubricate the impeller before installation.
2. Lubricate impeller blades with a non-petroleum based
lubricant such as silicone or soapy water. Install impeller
using a twisting motion and be sure the impeller blades
are bent in the same direction as they were upon removal.
Be sure impeller is installed in same direction as removed
if reusing existing impeller.
3. Rotate impeller to align keyway and slide the key in
place. Install impeller end cap in end of impeller bore.
RG9853
—UN—05JAN99
Install Cover Plate
A—Cover Plate B—Cam Screw
4. Using a new O-ring, install cover plate (A) onto impeller
housing. Install six screws with washers. Tighten screws
evenly.
5. Reconnect all water piping, if disconnected.
6. Open sea cock and prime sea water pump with water.
Start engine and check for leaks.
LOCTITE is a registered trademark of Loctite Corp.
OM-C3 | 12/6 | 60