North Star M157597AG, Руководство пользователя

Страница: 28 / 64

Operation
28
Lock trigger safety latch when not spraying . Spray gun is equipped with a built-
in trigger safety latch to guard against accidental trigger release. Rotate safety
latch to the locked position when not spraying.
Leaving unattended . Always turn off the pressure washer and relieve system
pressure before leaving the sprayer unattended.
Prompt Emergency Response
Seek medical aid for suspected injection injury . If injured by high-pressure
fluid, no matter how small the wound is, see a doctor at once. A typical injection
injury may be a small puncture wound that does not look serious. However,
severe infection or reaction can result if proper medical treatment is not
administered immediately by a doctor who is familiar with injection injuries.
Seek medical aid for suspected carbon monoxide poisoning . The running
engine gives off carbon monoxide, a poisonous gas that can kill you. If you start
to feel sick, dizzy, or weak while using the pressure washer, shut off the engine
and get to fresh air RIGHT AWAY. See a doctor. You may have carbon
monoxide poisoning.
Put on personal
protective gear
WARNING :
Use personal protective gear to prevent:
- Eye and skin injection injury from high pressure spray
- Burns from hot water or steam
- Eye injury from flying debris
1. Wear waterproof, thermally insulated gloves, safety glasses with side
and top protection, face protection, and protective clothing when
operating the machine. If spraying pressure washer specific chemicals,
wear a respirator mask to avoid inhalation of vapors if directed on the
chemical label.
2. Wear non-slip, protective footwear. Use of pressure washer can create
puddles and slippery surfaces. Wear footwear capable of maintaining a
good grip on wet surfaces.
Prime the water
supply Prime the water supply.
CAUTION: Never run the pump without the water supply connected
and turned on.
Operating the pressure washer without a sufficient
incoming flow of water will damage the pump.

Make sure the water feed tank contains adequate water.

Purge air from the water supply hose by squeezing the trigger until a
steady stream of water flows out of the nozzle at low pressure. (Air in
the hoses can cause damage to the pump, so always make sure all the air
is out of the hoses before starting the pressure washer engine.)
Start engine Start the engine to power the pump.
1. Make sure water supply is connected and primed.
CAUTION: Running the pump dry will cause damage and void the
warranty.
2. To prevent accidental spraying, engage the safety latch on spray gun