6
STEP 7:
Attach the 3/8” boom supply hose to the
3/8” hose barb and attach with the hose
clamp. Complete the adjustment of the
boom mount pivot by rotating the boom
assembly until the upright of the nozzle
arm is perpendicular to the ground.
Tighten the 5/16-18 flange bolts(the
pivot is to accommodate angled
hitches).
STEP 8:
Loosen the nut on the 3/8” hose barb fitting and slide the Nozzle up or down on the
upright until the nozzle is 24” above the ground.
24"
01127
STEP 9:
Attach the tank to the ATV as described in your spot sprayer manual. Attach the
boom supply hose to the remaining hose barb on the y-valve.
REMOVING THE BOOM KIT
1.
Make sure the pump is unplugged, and the valve to the boom supply hose is closed.
2.
Unscrew the y-valve fitting connected to the boom supply hose.
3.
Remove the 3/4” bolt attaching the boom kit to the ATV hitch.
OPERATING INSTRUCTIONS
1.
With the unit turned
OFF
, check nozzles for debris or damage. Also check for worn
hoses and system leaks. Repair before operating.
2.
Unfold the left and right boom arms.
3.
Once the water and chemicals are well mixed in your sprayer tank, open the valve
that is attached to the boom supply hose. Use the valve to turn the boom on and off as
desired (
If you have the 268180, you can also use the remote switch to turn the boom
on and off).
If you use the spray gun while the boom is operating, you will not get the
correct coverage from your boom.
4.
Drive at the desired speed, as calculated by tables 1 and 2 on the next page.
5.
To operate the spray gun, close the valve leading to the boom and make sure the
valve leading to the gun is open.
02390
3
8
" BO O M S U PP L Y H O S E
3
8
" H O S E C L A M P
