North Star Design Vines NSD10033, Инструкция по уходу и эксплуатации

Страница: 6 / 6

NSD10033
AssEmBlY INsTRUcTIONs
NSD10033
AssEmBlY INsTRUcTIONs
FREqUENTlY AskED qUEsTIONs
cOnTinued
How much water do I need to keep in the water feature?
Where possible in our water features, we have included fill lines to help
you visualize the water level required for proper function. If your water
feature does not include fill lines, please check the instruction manual for
water capacity. The most important aspect to keeping your water feature
functioning is to insure the pump is submerged in water at all times to
prevent damage to the pump.
How often will I need to fill my water feature?
Over time, the water level in your water feature will recede. This is due
to evaporation, and the speed at which your water feature will need to
be filled depends greatly on your environment- the humidity, if your
water feature is in the sun, how often you run the water feature, etc. We
recommend checking the water level before running the water feature to
insure the pump is submerged in water.
Can lights be turned off separately from the water feature?
Water features that include lights will have a separate plug and switch for
the lights. They do not have to be plugged in or turned on to run the
water feature.
My pump is making a loud noise. How do I fix that?
1. Be sure the pump is fully submerged in water. If it is not, and pulling
in air, it will make unwanted noise.
2. Check to make sure the pump is not touching the water feature
anywhere other than the bottom. If it is up against the side wall or
another part, the vibration from the pump can cause unwanted
noise. If moving the pump away from other parts does not work, try
placing a sponge or other soft material between these areas to pad the
pump.
FREqUENTlY AskED qUEsTIONs
cOnTinued
How do I change my pump speed?
Depending on the type of pump,
you will need to either move the slider or turn the knob.
How do I clean my pump?
1. Disconnect the power supply and then remove pump cover/filter.
2. Gently pull impeller/rotor assembly out of the pump housing
3. Rinse the impeller/rotor assembly and the cavity with clean water.
4. If your pump comes with a sponge filter rinse this with clean water.
Algae buildup can be flushed out with a garden hose.
How do I level the water feature?
For the water to flow properly, it is critical the water feature is level. If your
water feature will be placed in an area with uneven ground, use leveling
shims and a level to help level the water feature before adding water. Shims
are wedge-shaped plastic parts that can be placed between the water feature
and the ground to create a level surface.
My tube is too long. What can be done to fix this?
The hose can be cut with a sharp blade or pair of scissors to the desired
length.