Wave PERFORMANCE Monitors (PPCs)
Specifications subject to changes without prior notice. The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
[email protected] www.northinvent.com
6
7. Electrical Installation
All electrical connections are to be found on the lower backside of the Panel PC. The connectors are clearly labelled on the
Terminal Plate at the bottom of the Panel PC’s backside.
Figure: Terminal Plate for a Panel PC with AC+DC power input and four serial ports. Optionally, two serial ports can be
replaced with two additional Ethernet ports.
7.1. Pin-Assignments
AC Power
Pin
Description
Pin
Description
Pin
Description
N
Neutral
PE
Protective Earth
L
Line
The Panel PC is connected to AC voltage by means of the standard AC power cable included in the delivery. The AC
current to the Panel PC is limited by a 3.15 A internal fuse.
DC Power
Pin
Description
Pin
Description
Pin
Description
1
Supply voltage, positive 18-36V
2
NC
3
Supply voltage negative
The Panel PC is connected to DC voltage by means of the DC power plug included in the delivery and wires suitable for up
to 8 A continuous load. The Panel PC will not be damaged by reversed polarity; may it occur. The DC current to the Panel
PC is limited by a 10 A internal fuse.
