Accessing the Service Console Interface A-5
Nortel IVR 2.5/S Aculab-Based E1 CAS/ISDN PRI Signaling Guide
Using the LAN to access the SCI
To access an MRS across a LAN, the MRS must be connected to either an
Ethernet or Token Ring network, and the host that will access the MRS must
support TCP/IP and telnet (or rlogin).
To access the SCI, follow these steps:
1
At the host command line, enter the command:
telnet
128.1.1.111
Note 1: If the Internet address for your MRS has been changed, enter
the correct Internet address instead of the default address shown. This
address is noted on your equipment list.
Note 2: If the host is an X Window-based UNIX workstation, Nortel
recommends that this command be issued from an xterm window.
2
Once the session is connected, the following message should display:
login:
3
At the
login:
prompt, enter the appropriate account name. The
default passwords for these accounts are as follows:
4
After you log in, the system prompts you for your terminal type. If the
default terminal type displayed is correct, press <Enter>; otherwise,
type in the correct terminal type.
Once this is completed, the SCI menu is displayed, followed by the
/sci>
prompt.
Note: On an MRS/AP, if you log in as root, a
#
prompt is displayed. At
the
#
prompt, type
/usr/vrs/tools/sci -b /usr/vrs
and press
<Enter> to access the SCI menu.
Account
Password
Used by
root
profile
Trained Service Personnel
service
access
Trained Service Personnel
admin
supervise
Site Administrators
user
nortel
Routine Maintenance