Installing ISDN BRI hardware
Page 25 of 120
Installation and Configuration
5
Push the tabs firmly against the front panel of the card so they latch to the
front lip in the module and to the post on the card.
6
Observe the red LED on the MISP faceplate.
•
If the red LED lights and stays lit continuously without flashing three
times, the card is defective. Remove the MISP, choose a new MISP,
and repeat the installation procedure.
•
If the red LED lights, flashes three times, and turns off, the MISP is
operating correctly and is configured and enabled. Go to step 7.
•
If it lights, flashes three times, and stays lit continuously, the MISP is
operating correctly but is not configured and enabled. Go to step 7.
7
Repeat steps 1 through 6 for each MISP requiring installation.
End of Procedure
Procedure 4
Removing the MISP
Perform the following steps to remove the MISP.
1
Hold the MISP by its card-locking devices. Squeeze the tabs to unlatch
the card-locking devices and lift the tabs out and away from the card.
2
Carefully remove the MISP from its card slot, and slowly slide the card
from the module.
End of Procedure
Procedure 5
Installing the BRSC, SILC, and UILC
After MISPs are installed, install SILCs, UILCs, and BRSCs, as required. As
the cards are installed, keep a list of the card type (BRSC, SILC or UILC), the
module number, and the number of the card slot containing the card. Use the
Core/Network Module card location form or the IPE Module card location
form at the end of this chapter to document this information.
1
Hold the card by its card-locking devices. Squeeze the tabs to unlatch the
card-locking devices and lift them away from the card.
2
Insert the BRSC, SILC, or UILC into the selected card slot of the module
so it engages the card guides in the module.
Содержание Communication Server 1000M
