Nortel BCM50 2.0, Руководство по установке

Страница: 54 / 86

54 Chapter 7 Registering Nortel 20XX and 11XX IP telephones
NN40020-309 NN40020-309
Notes:
• If the DN record is not configured yet, as is the case with auto-assigned DNs, you can only
place local calls until other lines are assigned in the DN record.
• If the telephone has not been registered before, you receive a
New Set
message. Enter the
information, as prompted. Refer to “Registering the telephone to the system” on page 50 .
Table 4 describes the values for each display parameter.
Table 4 IP telephone server configurations (Sheet 1 of 2)
Field Value Description
DHCP 0 or 1 Enter 0 if your network is not using a DHCP server to dispense
IP addresses. (Static DHCP)
Enter 1 if your network does use a DHCP server.
If you choose to use a DHCP server rather than allocating static
IP addresses for the IP telephones, skip the remainder of this section.
If DHCP = 0
SET IP <IP address> The set IP must be a valid and unused IP address on the network to
which the telephone is connected.
NETMASK <subnet mask
address> This is the subnet mask. This setting is critical for locating the system to
which you want to connect.
DEF GW <IP address> Default Gateway on the network (for example, the nearest router to the
telephone. The router for IP address W.X.Y.Z is usually at W.X.Y.1).
If there are no routers between the telephone and the system network
adaptor to which it is connected, (for example, a direct HUB
connection), then enter the Published IP address of the BCM50 as the
DEF GW.
If the IP telephone is not connected directly to the Published IP address
network adapter, set the DEF GW to the IP address of the network
adaptor to which the telephone is connected.
Emulation Key
Mapping 0 or 1 0 = Handset
1= Handsfree
Default setting is 1 (handsfree) and should not be changed.
Note : This setting applies to the 2033 model only.
If DHCP = 1
Manual Cfg?
DHCP:
Full = 0
Partial = 1
If you indicate DHCP for the telephone, but you want to enter static
IP addresses, choose 1 (Partial).
If you choose 0 (Full), the DHCP server assigns IP addresses that are
not static.
If DHCP = 0 or Partial
S1 IP <IP address> This is the Published IP address of the first system to which you want to
register the telephone.
S1 PORT Default: *7000 This is the port the telephone uses to access this system.
S1 ACTION Default: 1
S1 RETRY COUNT <digits between 0
and 255> Set this to the number of times you want the telephone to retry the
connection to the system.
S2 IP <IP address> This is the Published IP address of the second system to which you
want to register the telephone. It can be the same as the S1 setting.