Nortel 2332 Series, Руководство по установке

Страница: 53 / 144

Installing and connecting a Series 2332 Access Point 53
Nortel WLAN Series 2332 Access Point Installation Guide
Figure 29. Step 9—Locking the Bracket
11
To ensure that the AP is fully locked onto the bracket, gently pull on the access point and attempt to rotate
it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as described in step 10 on
page 52 .
12
If the other end of the Cat-5 cable is not already connected and the link activated, then go to “Connecting
an AP to a WSS” on page 53 . Otherwise, go to “Verifying AP health” on page 55 .
Connecting an AP to a WSS
You can connect an AP directly to a WSS or indirectly to the switch through an intermediate Layer 2 or Layer 3
network.
• To connect the AP directly to a WSS, configure the WSS port as an AP and use the following procedure to insert
the cable into the WSS and verify the link.
• To connect the AP indirectly to a WSS though the network, configure a Distributed AP connection on the WSS.
You can use the CLI or WLAN Management Software to configure an AP or Distributed AP connection. (See the
Nortel WLAN Security Switch 2300 Series Configuration Guide or the Nortel WLAN Management Software 2300 Series
User Guide .)
840-9502-0062
Lock