Page 6 Reznor, PVE, Installation Manual EN 2019-11, D301113 iss D
If the country code and gas category on the
appliance data label does not match the
country of installation or the country codes
and gas category’s as shown in this instruction
manual, it will be necessary to contact the
distributor or manufacturer to provide the
necessary information for the modification of
the appliance to the conditions of use for the
country of installation
Directives applied
• Gas Appliance Regulations (EU) 2016 /
426.
• Machinery Directive (2006 /42 / EC)
• Low Voltage Directive (2014 / 35 / EU)
• Electromagnetic Compatibility Directive
(2014 / 30 / EU)
• Product Liability Directive (85 / 374 / EEC)
• Eco-Design Directive (2009 / 125 / EC)
General product
information
There are six PVE models with outputs ranging
from 29.4 kW to 144.0 kW.
PVE heaters are suitable for operation on
Natural gas (G20), Natural gas (G25), Natural
Gas (G25.3) or L.P.G (Propane G31)
The PVE range are available for floor mounting
only.
PVE heaters have been approved for
alternative flue discharge arrangements but
each heater must be connected to its own
individual open flue these are detailed in the
section flue installation
Cabinet
Manufactured from electro-zinc coated steel,
finished in a durable stove enamelled polyester
powder paint.
Heat Exchanger
This heater is equipped with a patented
T-CORE2® heat exchanger
Flue/Combustion Air Spigot
Each heater is fitted with two spigots both
of which are located on top of the appliance.
One of the pair is for connection for the flue
whilst the other is a screened combustion air
intake see section: Flue installation
Burner Control
The heaters are fitted with automatic ignition
for all models within the range
Exhaust Fan
Combustion gases are evacuated to
atmosphere via an in built power flue venter
fan, which is safety interlocked to the gas
valve via an air pressure proving device
Air Movement Fan
PVE heaters are supplied with Centrifugal fans
suitable for ducted or free blowing
Heater model examples
Figure 1 Model recognition
PVED 30 (duct)
PVEN 30 (nozzle, 2)
