Encore Manual Spray Gun - Trigger Switch Replacement
7
Part 1096694A
E
2009 Nordson Corporation
14. With your finger or a wooden dowel, align the inside end of the outlet
powder tube (14) with the elbow (13) then push on the tube to seat it in
the elbow.
15. See Figure 14. Install the display module as follows:
a. Make sure the display module switch mounting surface is clean and
dry. Clean old adhesive off with isopropyl alcohol and dry before
connecting the new switch.
b. Remove the two adhesive liners from the connector side of the
trigger switch header.
c. Align the trigger switch header with the display module receptacle
and push on the header to connect it. Apply even pressure on the
header to seal it tightly against the display module.
d. Remove the liner from the new adhesive support pad and install it
over the trigger switch header. Apply even pressure on the support
pad to secure and seal it to the display module.
e. Connect the display module and gun cable J3 connectors together.
f.
Gently fold the trigger switch ribbon cable and display module cable
into the gun, and install the display module onto the gun.
g. Secure the module with the bottom (M3 x 20) screw (12).
h. Slide the hook (10) onto the display module and secure it with the
top (M3 x 30) screw (11).
11
12
9
10
Adhesive
Support Pad
J3
Switch
Header
Adhesive
Liners
Figure 14
Display Module Installation
