Encore Manual Spray Gun - Trigger Switch Replacement
4
Part 1096694A
E
2009 Nordson Corporation
Gun Assembly
New Trigger Switch Installation
1. Remove the adhesive liner from the new trigger switch.
2. See Figure 8. Install the trigger switch (15) on the mounting flat of the
right handle (25), using the locator tabs and bottom flat to orient the
switch. Press firmly on the switch to secure it in place.
3. Install the actuator (18) and settings trigger on the main trigger (17),
noting the orientation of the settings trigger (16) gusset. Slide the
triggers over the trigger pivot pin on the right handle half.
15
18
17
16
25
Gusset
Pivot Pin
Locator Tabs
Bottom Flat
Figure 8
Trigger Switch Installation Steps 1-3
Assembly
1. Align the right and left handle hex pins with their mating sockets and
press the handles together.
2. See Figure 9. Feed the cable (28) connectors into the bottom front of
the handle, then slide the inlet tube (23) through the tube guides while
routing the cable (28) out the top of the handle. Leave the base about
1.5-2 inches from the bottom of the handle.
3. Route the 4-mm clear tubing from the gun body through the handle and
connect it to the barbed fitting (20) in the base, if previously
disconnected.
