Nordson 1601051-02, Руководство пользователя

Страница: 14 / 22

Trilogy
r
Air-Assisted Airless LT Manual Spray Gun
10
Part 1601052-03
E 2016 Nordson Corporation
Maintenance
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
WARNING: High pressure fluids are extremely dangerous. Relieve all fluid
and air pressure to the gun before performing these procedures.
Spray Gun Flushing
When spraying is done for the day, supply the delivery pump with a solvent
or waterborne cleaning solution compatible with the paint used. Spray until
it runs clear. Never immerse the spray gun in solvent or cleaning
solution.
Nozzle Cleaning
1. Stop the pump and relieve the fluid pressure.
2. Pull the trigger to relieve any remaining pressure in the gun.
3. Rotate the trigger lock 90 degrees upward to lock the gun.
4. See Figure 4. Remove the air cap retainer, air cap, and nozzle (1, 2, 3).
Blow out the nozzle with compressed air, from the front. Clean the
nozzle and air cap with a soft-bristle brush and a compatible solvent or
waterborne cleaning solution.
NOTE: Use only tools designed for nozzle cleaning to clean the nozzle
orifice. Contact your Nordson representative for nozzle cleaning kits.
5. Re-install the nozzle into the air cap, making sure the pin in the air cap
slides into the groove in the nozzle. Install the air cap on the gun, and
secure it with the retainer.
6. Adjust the air cap orientation and hold it while tightening the retainer
securely by hand.
Filter Cleaning
The filter should cleaned periodically to prevent paint residue from
hardening inside the filter and housing. The frequency of cleaning depends
on the type of paint used.
1. Stop the pump and relieve the fluid pressure.
2. See Figure 4. Unscrew the hose connector (16) with a wrench.
3. Remove the filter (17) from the housing (18).
4. Clean the filter with a compatible solvent and soft brush. Do not use a
wire brush as it will damage the filter.
5. Flush the hose connector with solvent.
6. Install the cleaned filter, or a new filter, into the housing.
7. Screw the hose connector back onto the housing and tighten securely.