Nordson 1601051-02, Руководство пользователя

Страница: 12 / 22

Trilogy
r
Air-Assisted Airless LT Manual Spray Gun
8
Part 1601052-03
E 2016 Nordson Corporation
Atomizing Air Adjustment
See Figure 1. Rotate the atomizing air regulator (1) to the right (clockwise)
to decrease air flow, to the left (counterclockwise) to increase air flow.
Fan Pattern Adjustment
See Figure 1. Rotate the fan pattern regulator (2) to the right (clockwise) to
decrease air flow, to the left (counterclockwise) to increase air flow. At
minimum flow, the pattern is flat; at maximum flow the pattern is round.
Air Cap Adjustment
See Figure 2. The position of the atomization air cap and the nozzle
determines the orientation of the fan pattern.
1. Stop the fluid pump and relieve the fluid pressure.
2. Pull the trigger to relieve any remaining pressure in the gun.
3. Rotate the trigger lock 90 degrees upward to lock the trigger.
4. Loosen the air cap retainer.
5. Rotate the air cap to the desired position, hold it in position, then tighten
the retainer securely. The nozzle rotates with the air cap.
Air Cap Horns
Air Cap Horns
Figure 2 Air Cap Position Determines Fan Pattern Orientation
Coating Tips
See Figure 3. Use these tips to help you obtain a quality coating:
S
Hold the spray gun at a 90 degree angle to the surface being coated. If
held at a different angle, the coverage will be uneven and flawed.
S
Use your arm, not your wrist, to move the gun parallel to the surface.
Do not wave the gun with your wrist.
S
Begin moving the gun before pulling the trigger. Move the gun back and
forth at an even speed. This will ensure even, smooth overlapping
patterns without any buildup where the trigger is pulled.
S
Release the trigger before stopping arm movements.
S
Immerse the gun nozzle in solvent or waterborne cleaning solution
during pauses in production to prevent coating material from hardening
on the nozzle.