7
2. Identify the Right Upright (92), which is marked
with a “Right” sticker.
Have a second person hold the Right Upright
(92) near the Right Base Cover (102).
See the
inset drawing.
Tie the wire tie in the lower end
of the Right Upright securely around the end of
the Upright Wire (93). Then, pull the other end
of the wire tie in the top of the Right Upright until
the Upright Wire is routed completely through
the Right Upright.
Gently pull up on the Upright Wire (93) as you
set the Right Upright (92) on the Base (103) in-
side the Right Base Cover (102).
Be careful not
to pinch the Upright Wire.
Attach the Right Upright (92) to the Base (103)
with two 3/8" x 3 3/4" Bolts (5) and two 3/8" Star
Washers (6). Note: It may be necessary to tip
the top of the Right Upright forward slightly as
you thread the Bolts into it.
Do not tighten the
Bolts yet.
Attach the Left Upright (91) in the same way.
Note: There are no wires on the left side.
103
93
102
2
92
6
5
91
93
92
Wire
Tie
Wire
Tie
103
Cardboard
Stand
1.
Make sure that the power cord is unplugged.
With the help of a second person, raise the front
of the treadmill and insert the crossbar on the
Base (103) into the cutout in the cardboard
stand as shown.
Have the second person hold
the treadmill until assembly step 3 to prevent
it from moving forward or backward.
WARNING:
Serious injury
may occur if the treadmill moves for-
ward or backward and falls off the card-
board stand. A second person must
hold the treadmill until assembly step 3
to prevent the treadmill from moving,
tipping, or falling.
1
