23
HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect the 96" A/V Wire or a CATV cable to
the treadmill (see page 13).
1. Turn on the television.
If there is a sheet of clear plastic on the television
screen, remove the plastic. Insert the key into the
console. See HOW TO TURN ON THE POWER on
page 16. Press the TV power button to turn on the
television. Note: If you operate the television with-
out inserting the key into the console, the buttons
on the console will not function.
2. Initialize the DTV mode.
If there are no channels saved in memory in the
DTV mode, the television may prompt you to adjust
the television settings. Select your country, lan-
guage, and time zone. Time zones are set from
Greenwich Mean Time (GMT). Then, highlight Exit
and press the Volume increase button on your re-
mote control. Select Yes to scan for channels or
No to scan for channels later.
3. Scan for television channels.
Before operating your television, you must scan for
channels. See pages 26 and 27 for information on
scanning for channels. Note: You must connect a
VCR or DVD player and scan for channels before
you can use a VCR or DVD player. Make sure the
VCR or DVD player is connected correctly (see
page 13).
Your television can receive analog and digital sig-
nals. For the television to operate properly, good
reception is necessary. Make sure the television
settings are set correctly (see pages 26 and 27). If
you are using an antenna, make sure that it is
properly connected and adjusted for optimal recep-
tion (see HOW TO CONNECT AN ANTENNA on
page 13).
4. Press the TV/AV button to select an input
mode.
Select an input mode by pressing the TV/AV button
on the remote control repeatedly until the selected
mode appears on the screen. If you have con-
nected an antenna or a 75 ohm CATV cable to the
75 ohm terminal on the treadmill, select the TV
mode to view analog television or the DTV mode to
view digital television. If you have plugged the 96"
A/V Wire into the audio/video input jack, select the
AV mode. Note: For best results, press the TV/AV
button on the remote control only.
5. Press the Channel buttons to select the desired
channel.
When you turn on the television, the screen will
show the last channel that was selected. To select
a different channel, press the numbered channel
buttons or the Channel (CH) increase and de-
crease buttons. The selected channel number will
appear on the screen for a few seconds. Note:
Before channels can be selected, they must be
saved in the televisionʼs memory. If a channel no
longer appears, rescan for channels. See pages 26
and 27.
6. Press the Volume buttons to adjust the volume.
Press the Volume (VOL) increase or decrease but-
tons on the console to adjust the volume. Note: For
best results, change the volume by pressing the
Volume buttons on the console only.
To use earphones or
headphones (not in-
cluded), plug them into
the headphone jack near
the Start button on the
console.
7. Turn off the television.
When you are finished using the television, hold
down the TV power button for several seconds to
turn off the television. Note: If you do not turn off
the television, the television will automatically turn
on the next time you use the treadmill.
Headphone Jack
