NordicTrack Commercial 400, Руководство пользователя

Страница: 9 / 24

9
9. Attach the Handlebar (7) to the Upright (2) with four
M6 x 32mm Button Screws (69).
10. While another person holds the Console (4) near
the Upright (2), connect the console wire to the
Main Wire Harness (43). Next, connect the console
pulse wire to the Upper Pulse Wire (42). Then, con-
nect the console ground wire to the Ground Wire
(61).
Tip: Start all screws before tightening any of
them. Also, avoid pinching the wires during this
step. Insert the excess wires downward into the
Upright (2). Attach the Console (4) to the Upright (2)
with four M4 x 16mm Round Head Screws (68).
10
42
Console
Wire
Ground
Wire
Pulse
Wire
4
68
68
7
69
2
2
9
69
43
61
8. Have another person hold the Upright (2) near the
Frame (1). Locate the wire tie (see the inset draw-
ing) in the Upright. Tie the lower end of the wire tie
to the Main Wire Harness (43) and to the Upper
Pulse Wire (42). Next, pull the upper end of the
wire tie upward out of the top of the Upright. Then,
untie and discard the wire tie. Tip: Do not allow
the ends of the wires to fall into the Upright. Use
a piece of tape or an elastic band to hold the
wires in place until step 10.
Tip: Avoid pinching the Main Wire Harness (43)
and the Upper Pulse Wire (42) during this step.
Attach the Upright (2) to the Frame (1) with four
M8 x 18mm Button Screws (67) and four M8 Split
Washers (93). Tip: Tighten the two Button
Screws on the front of the Upright before tight-
ening the other two Button Screws.
8
2
67
67
67
1
93
93
93
93
43
42
Avoid pinching the
wires during this step
42
43
Wire
Tie