NordicTrack 4400r Treadmill, Руководство пользователя

Страница: 9 / 38

9
8. Remove the knob from the pin. Make sure that the collars
and the spring are on the pin as shown.
Press the Latch Insert (77) into the left side of the Upright
(20) as shown. Use a rubber mallet if necessary. Insert the
pin into the Latch Insert. Tighten the knob back onto the
pin.
77
8
Knob
20
Pin
Collar
Spring
9. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 30). To protect the
floor or carpet from damage, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 26) after the treadmill is assembled, follow the
steps below to install the receiver included with the chest pulse sensor.
1.
Make sure that the power cord is unplugged.
Remove
the indicated 3/4” Screw (7) and the Access Door (95)
from the left side of the Console Back (96).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (96).
Hold the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back.
Attach the receiver to the
plastic posts on the Access Door (95) with the two in-
cluded small screws.
3.
Make sure that no wires are pinched.
Reattach the
Access Door (95) with the 3/4” Screw (7). The other
wires included with the receiver may be discarded.
A
96
Small
Cylinder 7
95
Wire
Small
Screws