30
Most incline trainer problems can be solved by fol-
lowing the simple steps below. Find the symptom
that applies, and follow the steps listed. If further
assistance is needed, see the front cover of this
manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see
page 14). Use only a surge suppressor that meets
all of the specifications described on page 14.
IMPORTANT: The incline trainer is not compat-
ible with GFCI-equipped outlets and may not be
compatible with AFCI-equipped outlets.
b.
After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the incline
trainer frame near the power cord. If the switch pro-
trudes as shown, the switch has tripped. To reset
the power switch, wait for five minutes and then
press the switch back in.
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console, and then
reinsert it.
d. If the incline trainer still will not run, please see the
front cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a. The console features a display demo mode,
designed to be used if the incline trainer is dis-
played in a store. If the screen remains lit when you
remove the key, the demo mode is turned on. To
turn off the demo mode, see step 7 on page 24.
SYMPTOM: The console does not display speed
and distance correctly
a. Remove the key from the console and
UNPLUG
THE POWER CORD.
Next, remove the indicated
#8 x 3/4" Screw (5), and lift off the Left Foot Rail
Cover (44).
Next, locate the Reed Switch (67) and the Magnet
(45) on the left side of the Pulley (42). Turn the
Pulley until the Magnet is aligned with the Reed
Switch.
The gap between the Magnet and the
Reed Switch must be about 1/8 in. (3 mm).
If
necessary, loosen the #8 x 3/4" Truss Head Screw
(8), move the Reed Switch slightly, and then
retighten the Truss Head Screw. Then, reattach the
Left Foot Rail Cover (44) with the #8 x 3/4"
Screw
(5), and run the incline trainer for a few minutes to
check for a correct speed reading.
TROUBLESHOOTING
Reset
Tripped
c
5
44
45
42
a
8
67
1/8 in.
Top View
Содержание 24928.0
Страница 5: ...5 ...
Страница 6: ...6 all STANDARD SERVICE PLANS ...