Nordic POBA3200, Руководство по эксплуатации

Страница: 4 / 8

4
NORDIC
PRODUCT DESCRIPTION AND SPECIFICATIONS
While reading the operating instructions, unfold the graphics page for the machine and leave it open.
INTENDED USE
The cordless worklight is intended for mobile illumination in limited space and for limited time in dry indoor
and outdoor areas and is not suitable for general room lighting.
ASSEMBLY
BATTERY CHARGING (ACCESSORY)
Note: The battery supplied is partially charged. To ensure full capacity of the battery, completely charge the
battery in the battery charger before using your worklight for the first time.
The lithium-ion battery can be charged at any time without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the “Electronic Cell Protection (ECP)”.
When the battery is empty, the cordless worklight is switched off by means of a protective circuit.
Do not continue to press the On/Off switch after the cordless worklight has been automatically
switched off. The battery can be damaged.
To remove the battery , pull the battery toward the rear out of the cordless worklight.
Do not exert any force when doing it. Observe the notes for disposal.
OPERATION
INITIAL OPERATION
Inserting the battery
• Insert the charged battery into lamp head until it can be felt to engage and faces flush against the lamp head .
Standing Up
• Carefully fold out the pedestal and place the cordless worklight
on the floor. Ensure that it has a firm footing.
Fastening to the tripod
• You can use the tripod mount to screw the cordless worklight onto a tripod.
• Tighten the screw. Ensure that the tripod has a firm footing.
Switching On and Off
• To start the cordless worklight, press the On/Off switch .
• To switch off the cordless worklight, press the On/Off switch again. To save energy, only switch the cordless
worklight on when using it.
