Nordic POBA2350, Руководство по эксплуатации

Страница: 6 / 12

6
NORDIC
6. PRODUCT ACCESSORIES
1. Chuck
2. Depth ruler
3. Auxiliary handle
4. Function selection knob
5. Switch
6. Battery (not included)
7. Charger (not included)
8. Battery latch button
7. BEFORE YOU START
7.1 FITTING AND CHANGING TOOLS (FIG. 2)
The device is equipped with a SDS plus attachment system.
• Clean tools and grease with a thin layer of machine grease before fitting.
• For assembly, pull back fastening sleeve and hold. Push and rotate the dust-free tool into the tool holder as far as it
will go. The tool will lock automatically. Check that it has locked by pulling the tool.
• To remove SDS-plus tool, pull back fastening sleeve and remove tool.
Warning: Accessories can be hot after use. Don’t touch the tip of accerroty by hand! Always use
protective gloves to remove the accessory!
7.2 DEPTH GUIDE (FIG. 3)
Your drilling depth can be pre-set and/or repeated by using the depth stop.
Insert the required drill bit. Fit the depth stop into the hole of auxiliary handle and set the required depth.
7.3 FITTING THE AUXILIARY HANDLE (FIG. 4)
Warning: Always use the tool with the auxiliary handle properly assembly .
Loosen the auxiliary handle by unscrewing it. Slide the auxiliary handle clamp over the collar behind the bit
holder. Rotate the side handle to the desire position and tighten the handle.
7.3 SELECTING THE OPERATION MODE (FIG. 5)
The rotary hammer drill can be used in the following operation modes:
Rotary drilling - For screwdriver and for drilling into steel, wood and plastics.
Hammer drilling - Simultaneous rotating and impacting for concrete and masonry drilling.
