Nordic ATWC Series, Инструкция по установке и обслуживанию, Страница: 105 / 106

PRELIMINARY: 24-Sep-2021 Page 105 002536MAN-00
13. Click on Erase—Program—Verify. Programming…. Wait
while status bar shows progress. The messages should
read as below when finished:
11. “Programming completed. Verification successful.”
Click on Run Application. This will take the control board
out of bootloader mode and back into normal operational
mode, so that the PC App can connect again.
16. Close the PIC32 program.
17. WAIT APPROXIMATELY 10 SECONDS. This gives the
control board time to reset, initialize and re-connect to the
PC USB port.
18. Go back to the PC APP and click on the Connect button.
Verify that the firmware version, shown in the title bar after
connection, has been updated. Perform any configuration
needed.
15. Wait until the programmer disconnects itself. The
messages should read as follows:
NOTE: Updating the firmware does not affect the configu-
ration settings.
12. Click on Load Hex File . Select the
M
GL_GEN2_V400.production.hex
(or higher version num-
ber) file, which is in the folder you created on the Desktop.
Reset to Defaults
These steps may be performed for troubleshooting, when the
control system is not acting as it should.
1. With PC App connected, go to menu Tools --> Configura-
tion and note all settings. They will need to be re-set
later.
2. Go to menu Tools --> Reset To Factory Defaults. Click
YES in the pop up window, and OK in the next window.
3. Go back to menu Tools --> Configuration . Re-select the
Model Series even if it already indicates the proper series,
as clicking on it will load the parameters for that series.
4. Select the Model Size and make any other changes that
apply to the particular system setup such as number of stag-
es, control method, etc.