
UK
Congratulations on your new NORDIC PLAY electric car
Start with checking that everything is in the packaging.
Please follow the below instruction manual and save it for later use.
1. Start by attaching the rear fender with three screws 3x12 mm.
2. Turn the car upside down and attach the rear axis in the two channels.
3. Detach the cables from the two engines. One at a time, R to R and L to L. Push the engines
over the axis and attach the cables again. Make sure to attach engines and cables correctly. At-
tach the rear wheels, make sure the rims hook into the engine. Now attach the wheel caps, make
sure the wheel caps hook into the wheel. Finish with a washer and finally attach a lock nut that is
tightened with the two included wrenches.
4. Install the pivot frame to the front wheels. Remember that the “eye” of the pivot frame should
come down over the guide shaft. The frame is attached with four screws 4x12 mm.
5. Attach a washer on each end of the axis. Attach the wheels and then the wheel caps, a washer
and finally a locking nut. Tighten them with the two included wrenches.
6. Assemble the two supports for the front fender with eight 4x12 mm screws. Turn the car and ca
-
refully push the supports into the two brackets until they click in place. Open the hood and check
that the fender is in place correctly. Attach with four 4x12 mm screws.
7. When the hood is open, connect the red cable to + to get power to the car.
8. The front grid is pressed down into the three fitting holes. Push until the grid clicks in place.
9. The side mirrors attaches to the holes on the side of the car.
10. The steering wheel attaches to the steering wheel stem. Be careful with the cable that is hid
-
den in the stem. The steering wheel is tightened with a screw 5x35 mm, that is inserted through
the steering wheel and stem and tightened with the included nut.
11. Attach the back seat frame and tighten with four 4x12 mm screws.
Charger
1 pc
Front wheels
2 pc
Rear axis
1 pc
Rear wheels
2 pc
Side mirrors
2 pc
Wheel caps
4 pc
Front grid/wind shield
1 pc
Front fender
1 pc
Front fender holders
2 pc
Rear fender
1 pc
Double seat
1 pc
Frame for back seat
1 pc
Roll cage
1 pc
Roll cage assembly parts 2
2 pc
Remote control
1 pc
Spanner wrenches
2 pc
Lights for roll cage
2 pc
Bag of screws
1 bag