Norcool CU-350 ECO, Руководство по эксплуатации и установке

Страница: 9 / 24

9
These compact units come in three models; CU-350 ECO, CU-450 ECO and
CU-900 ECO with varying capacity depending on the size of the cold room. They
are for installation in a recess in the wall of a cold room. Do not use foam insula-
tion when mounting the unit in the recess niche. The units have a ‘cold side’ – the
element which projects into the cold room and a ‘warm side’ – the element which
projects into the outside of the cold room.
They are designed for chilling food for use in private households and similar appli-
cations. The unit cannot be placed on the outside wall or against an uninsulated
garage. The correct temperature in the cold room will depend on correct con-
struction and insulation. Leave the refrigeration unit inactive after installation for
approx. 2 hours before connecting to the mains electricity. This will allow the oil
to run back into the compressor after transportation and installation. If it has been
stored in sub- zero temperatures, allow to stand for 24 hours at room temperature
before starting.
There must be an adequate distance to the ceiling over the unit on the warm side
to allow disposal of the hot air produced. The units require a power supply of 220-
240VAC 50 Hz and must be connected to an earthed min.10A mains socket. If the
power cable is not long enough (2.6m mains cable connected to warm side), call
an electrician to install an extra min.10A earthed socket. If the unit does not start
as soon as it is plugged in, it will start after a delay of up to 7 minutes. In the event
of full load or frequent door opening/closing, the compressor will run longer and
it will take longer to reach the desired room temperature. Keep the door closed as
much as possible. Ambient temperature on the warm side of the unit must always
be higher than set temperature inside the cold room, but must not exceed 38°C,
or be less than 16°C.
1. Product information