19
Refrigerator Service Manual / Manuel d'entretien du réfrigérateur / Manual de servicio del refrigerador
Modelos N1090 / Modèles N1090 / Modelos N1090
REMOVE AND INSTALL
Remove Unit
The rear of the refrigerator has sharp edges
and corners. To prevent cuts or abrasions, be
careful and wear cut resistant gloves.
1. Remove the white caps and screws from the sides of the
refrigerator interior.
2. Pull unit forward and remove the refrigerator from the
opening about 4 (four) inches.
3. Disconnect 12 volt DC power from the 12 volt DC
connector of the refrigerator.
4. Carefully pull the unit fully out of the opening.
CAUTION
!
Install Unit
The rear of the refrigerator has sharp edges
and corners. To prevent cuts or abrasions, be
careful and wear cut resistant gloves.
1. Carefully push unit partly into opening, allowing about 4
(four) inches free at the top of the refrigerator.
2. Connect 12 volt DC power to the 12 volt DC connector of
the refrigerator.
3. Carefully push unit fully back into opening using care not to
damage.
4. Insert the screws and white caps back into the sides of the
refrigerator interior.
5. Test the refrigerator operation.
CAUTION
!
TEST UNIT
Once the repair is complete, test the refrigerator by following
the instructions below. If necessary, refer to the User Manual.
1. Push and hold on /off button for 2 (two) seconds.
2. Push the temperature setting button to select the cooling
level 3.
3. After 10 (ten) seconds, the temperature setting will dim.
The blue light indicates that the refrigerator is functioning.
Wiring Pictorial
NO.
Description
1
Display Module
2
Input Power 12 VDC
3
Main PCBA Cooling Unit
4
Thermistor
5
Fan Cooling Unit
6
Fuse 15 A / Fusible 15A / Fusible 15A
Fig. 4: Wiring Pictorial
FA
N
C
T
12V IN
GND
NTC
RL
Y
RL
Y
L1
CX1
RV1
FUSE1
+
-
Red /
Rouge
White /
Blanc
+
-
+
-
+
F
D
C
P
T
White / Blanc
Brown /
Marron
Black / Noir
FUSE
Black / Noir
Red / Rouge
NOR000704A
1
2
3
4
5
6
