Norcold 3163G, Важная информация о продукте

Страница: 13 / 15

Thermostat Installation
1. Align the provided template with the kit as illustrated in Figure 10
Warning: Contents of the cooling unit under pressure. Rupturing the cooling unit
will release chemicals which can cause severe damage to the eyes and
skin. Use the provided drill template. Wear protective safety eye glasses
and clothing before drilling the pilot holes.
2. Using the 3/8" drill, 3/32" drill bit, and the provided template, drill two pilot holes as illus-
trated in Figure 10
3. Remove template and save for future installations.
4. Align the thermostat clearance holes with the pilot holes drilled in Step 2.
5. Insert the two #6 x 3/8" screws provided with the kit through the clearance holes of the
thermostat and into the pilot holes in the cooling units condenser fins.
6. Tighten screws to secure thermostat to the condenser fins.
7. Attach the black wire of the fan to the open 45
°
terminal on the refrigerators terminal block.
8. Attach the red wire of the fan to the bottom terminal of the fan terminal.
9. From the kit, remove the 20" red wire. Attach the female end to the top terminal of the fan
thermostat. Route the male end up and connect to red wire from the mode selection switch.
10. Proceed to the following section before re-installing the refrigerator.
Cooling Unit
Condenser Fins
Template
Thermostat
Mounting Screws
(#6 x 3/8")
Figure 10 - Eurovan Ventilation Fan Installation
11