Analog Input SmartLead
P-811 Rev B (May 2019)
15
Step 3
Once back in the Home
screen, choose if you
would like to create a new
configuration or edit an
existing configuration.
Step 4
In the measurement setup
screen, insert the Ultium
system into the Devices of
your configuration box.
It is recommended that
you redetect sensors in the
hardware configuration
every time the SmartLeads
are removed from the
Ultium sensor (redetection
is necessary to revert to
the use of the sensors
EMG functionality). This
will prevent configuration
errors leading to the
inability to collect a
measurement. If an error
message pops up when
starting a measure, and
you are using SmartLeads,
this is a good first
troubleshooting step (1.
Redetect sensors in
hardware set-up; 2. Double
check the configuration). *
See Find My Sensor
section below
