
Noraxon U.S.A., Inc.
myoMOTION Data Logger
P-6828 Rev A (Oct 2014)
6
Section 5: Getting Started
Quick
Start
Guide
To begin using the Data Logger, the user must charge the device using the USB A to mini-B
cable provided with the data logger. Once charged, it is necessary to setup the sensors, time and
date before a measurement can be taken.
Note
: It is important to press the Save button after each step to ensure the data logger stores
the changes and it will work properly.
For the initial setup: turn the Data Logger on and Press OK to enter the Setup screen.
1. Setup
Sensors
Assign Sensors
Enter the serial number of each sensor into the body
segment it will be attached to. This is also where the
footswitch sensors will be entered, if they are going to
be used.
Enable Sensors
Selects which sensors will be used in the recording
by selecting “ON”. Any sensors not enabled
(switched “OFF”) will not have any data recorded.
Note
: Any sensors mistakenly enabled but not being used,
will either create an inaccurate record or give an error if the
data logger is not able to communicate with the sensor.
Footswitches
Adjust the sensitivity of the footswitches
Configuration
a. RF Channel – the radio frequency (RF)
channel can be set to anything from A to F.
This determines the frequency at which the
sensors will communicate with the data
logger.
b. Sample Rate – the sample rate can be set to
100 or 200Hz.
c. Enable Accel – turns acceleration on and off
Note
: Research myoMOTION can measure 16 sensors at
100Hz with acceleration enabled, or 8 sensors at 200Hz
with acceleration enabled. Clinical myoMOTION can only
sample at 100Hz and does not have acceleration
capabilities.