
2.
When the desired charging mode is chosen, the charging process will start
automatically after 3 seconds. For example, if the 6A Charging Mode is selected, the
LCD screen will display the following
(The upper digital display shows the output
current that is charging the battery. The lower digital display indicates the
voltage of the connected battery. The Vehicle Icon, Clamp Icons and the Battery
Icon will light solid. The bars on the Battery Icon will change from empty to solid
(bottom to top) repeatedly and the Arrow Icons will gradually and repeatedly
move downward to the Battery Icon.)
, indicating the unit is in charging mode:
Vehicle 6A Charging Mode (Press twice):
In this mode, the unit charges the
battery at a higher rate of charge with the maximum current output to
approximately 6A and the LCD screen will display the following
(The upper
digital display will blink “6.0A” and the Vehicle Icon will flash. The Clamp
Icons, Arrow Icons and the Battery Icon will light solid)
for 3 seconds:
Alternator Check Mode (Press a third time):
In this mode, the unit will
perform the Alternator Check function to determine that the alternator is keeping
up with the electrical load. See the “Checking the Alternator” Section.
Standby Mode (Initial or Press a fourth time):
In this mode, the unit is ready to
use and will automatically start the charging process under the 2A Charging Mode
after one minute.
Note:
The only difference of the LCD representation between the charging modes is
the appearance of the Motorcycle Icon for 2A and the Vehicle Icon for 6A.
The charger will automatically detect the battery condition. If it detects a
problem with the battery, the charging process will automatically terminates and
the LCD screen will display the following (The Fault Icon and the empty Battery
Icon will flash, the Motorcycle or Vehicle Icon, Clamp Icons and the Arrow Icons
will light solid.):
A
INSTALLATION
122