Norac UC5 Can Bus, Руководство по установке

Страница: 29 / 41

26
6. Install the spring target and align by rotating the metal casing around the linear roll cylinder.
7. Install a sensor onto the sensor mounting bracket.
8. Mount the sensor bracket to the damper end (the end with no hoses). A straight edge can
be used to line up the spring target with the center of the hole on the sensor mounting
bracket. The mount should be facing as far forward as possible, but be sure it will not
contact the catwalk when the boom is raised to the top.
9. Mount the cylinder target to the cylinder end (the end with hoses).
10. Align the cylinder target (bottom rod) so that it is 5/8” to the side of the spring target
( Figure 26 ).
Figure 26: Linear Roll Cylinder Target Alignment
Top View
Side View
Sensor
Mount
Spring
Target
Cylinder
Target