10
7.
Adjust the targets and sensor bracket using a level or a plumb line. Ensure the sprayer is
level and the booms are level when installing the roll targets. The spring target must be
aligned on the centerline of the sensor. The Frame target must be aligned ½" to the left
side of the centerline. Both targets must be perpendicular to the sensor.
Figure 8: Target Rod Alignment (Side View)
8.
When the target positions are correct, ensure all mounting bolts are tight. Double-check
the target locations to ensure that they haven’t drifted out of position.
9.
Once alignment is correct, trim the top rod so it is 1 inch past the edge of the sensor, as
shown above in
Figure 9
.
Figure 9: Sensor and Rod Alignment as Viewed From Above
Spring Rod trimmed 1”
past edge of sensor
Spring Rod trimmed 1”
past edge of sensor
