9
2.
Remove the rubber bumpers on both ends of the roll frame (
Figure 4
).
3.
Assemble the roll sensor mounting bracket as shown in
Figure 6.
Figure 6: Roll Sensor Mounting Bracket
4.
Install the roll sensor bracket on the T-shaped black intermediate frame (
Figure 4
). The
sensor should be mounted between the parallel lift arms and the wheel in a position that
will not interfere with folding. Do not mount directly behind the wheel.
5.
Install the frame target (B07) onto the parallel lift frame. The frame target should be
mounted to the bottom of the boom carrier frame. The member that the frame target is
mounted to must NOT rotate with the boom and must be located 41” (104cm) down from
the bottom of the sensor as shown in
Figure 7
.
6.
Install the spring target (B08) onto the boom center section 16” (41cm) down from the
bottom of the sensor as shown in
Figure 7
. The spring target must be mounted to a frame
member that moves with the boom.
Figure 7: Target Location
Mount Frame
Target as close
to the vertical
member as
possible.
