Nome nmas Simple, Руководство пользователя

Страница: 33 / 35

nmas Simple
•
Pin5 = Cable shield
Ethernet ( m12 socket D-coded)
•
Pin1 = TX+
•
Pin2 = RX+
•
Pin3 = TX-
•
Pin4 = RX-
•
Pin5 = Cable shield
Tacho (m12 plug A-coded)
•
Pin1 = Tacho/NC
•
Pin2 = GND
•
Pin3 = 5 VDC Out
•
Pin4 = 24 VDC Out
•
Pin5 = Cabhle shield
Start measurements on nmas Simple
1. Attach unit to it's measurement location
2. Connect sensor cables. Match color codes on unit to cables
3. Place sensors to device under measurement
4. Connect tacho cable (optional)
5. Connect power supply
6. Measurements start after 30 seconds and new data is visible on nmas
LD screen
Start remote connections on nmas WR (optional)
1. Attach unit to it's location.
2. Connect power supply.
3. Check connection status on nmas Simple by pressing left
For wireless connection nmas has scanning timer of five minutes. Connection
will not be immediately visible on LD-trend display.
Configurating nmas Simple
On local display
1. Select desired figure on display by pressing Up/Down
2. Press Right to view trend
Page 33