Revised: 06/01/12
North America: 800.732.9395 Europe: +353.98.66011
Guide pedestal top underside onto
extrusion. Once, aligned push down
to engage it.
Align groove on the rear of the graphic
with the extrusion.
Tighten underside with hex wrench
provided.
Insert the top brass connector into the
groove. Tighten standoff cap to lock
brass connector into the extrusion.
Repeat on bottom of graphic.
Loosely attach standoff cap to a brass
connector on either side of the top hole
in the graphic.
Brass connector should be on the rear
of the panel. Repeat on bottom hole of
graphic.
Your product pedestal assembly is
complete.
Product Pedestal Setup Instructions
Follow steps on the “Graphic & Light
Instructions”.
Lay out pedestal parts.
Tap insert out of foot from underside.
Slide extrusion into front slot with
channel facing outward. Tighten inside
lock hole with hex wrench provided.
HangTen
Follow steps on the “Frame Setup
Instructions”.
Note: When tightening with hex wrench always give it a 1/2 turn clockwise until tight.
Accessories • 5
