Revised: 06/01/12
North America: 800.732.9395 Europe: +353.98.66011
Tuck the graphic edge from center out to
left and right corners along the top and
then bottom track.
Lights are connected to holes on the
top of your frame.
Fold excess corner fabric under and
press edge of fabric graphic onto
Velcro® on one side. Work your way
down the side of the frame.
Insert the peg base of the lights into a
hole on the top part of the frame.
Pull taut as you press edge of fabric
graphic onto Velcro®. Work your way
down the side of the frame. Repeat on
other side.
Your assembled HangTen display is now
ready for accessories.
Swivel fixture to adjust position.
Graphic & Light Setup Instructions
Lift assembled frame into upright
position. Insert top corners of fabric
graphic plastic edge into the horizontal
track along the top H1/H2 extrusions.
Tuck the plastic edge into the horizontal
groove about 3” to secure the top two
corners.
Insert lower corners of fabric graphic into
the horizontal track along the bottom
H1/H2 extrusion. Tuck the plastic edge
into the horizontal groove about 3” to
secure bottom two corners.
HangTen
Follow steps on the “Frame Setup
Instructions”. Alwas use white cotton
gloves provided when handling fabric
graphics to prevent soiling.
Note: When tightening with hex wrench always give it a 3/4 turn clockwise until tight.
Graphics • 3
