nomad Run 8.0, Руководство пользователя

Страница: 6 / 10

6

Assembly requires two persons

Assemble in a clean and level area

Before assembly take parts out but do
not dispose of any material until complete

Left parts are marked as “L”. Right parts
are marked as “R”

The treadmill might be covered by light
oil to preserve it from rust
1. Take out the base frame and lay it
out on a clean even floor
2. Connect the signal wire in the right
post. Place the right and left posts in
the base frame.
Use 10 x M8*20 screws to fasten the
posts to the base frame. Fasten
lightly until all screws are aligned
before tightening.
3. Connect the signal wire to the
console on either side of the upright
posts. Fit the console to the posts, be
careful not to crush the wire, it should
be clear of edges.
Use 4 x M8*20 screws to fasten the
posts to the console. Fasten lightly
until all screws are aligned before
tightening.
15
E
rr
o
r
C
o
d
e
s
E01 - Communication
failure
Communication wire damaged or
not connected
Replace or connect
communication wire
E13 - Communication
failure
Communication wire damaged or
not connected
Replace or connect
communication wire
E07 - Safety Key Safety key is not in place Place safety key on
allocated console
area
E02 - Stall protection Input voltage is low Check input (plug)
voltage
E03 - No speedo
sensor signal Speedo sensor wire damaged or
not connected Replace or connect
sensor wire
E04 - Incline error Incline motor or communication
wire damaged or not connected
Replace or connect
communication wire
Incline motor is broken Replace the incline
motor
E05 - Over current
protection Over currents has occur Turn the treadmill
off and on
Walking belt drive blocked or
stuck
Remove blockage or
adjust drive system
Motor is shorting Replace the motor
Motor is not spinning Input current too low
E08 - Memory error
(24C02)
Error with memory IC Check memory IC
(next to the “on”
switch)
E10 - Peak power error Motor belt tension too high Loosen motor
tension belt
Motor error Replace motor
Walking belt drive blocked or
stuck
Remove blockage or
adjust drive system
E06 - Motor error Connections damaged or loose Replace or tighten
connections
Motor is shorting Replace motor
Motor is not spinning Input current too low