7
!
9. Connect the wire inside the switch housing cap by snapping
the male and female connectors together
;
match white wires
together and blue wire to black wire together. Screw on light
kit assembly and switch housing with 3 screws previously
removed (Fig. 9).
Installing Glass shade
. Attach the glass shade to the light kit and turn clockwise
until tight (Fig. 9).
. Now your ceiling fan is assembled and ready for use.
Fig.9
Screws
Glass Shade
Light Kit
Restore power to the ceiling fan and test for proper operation.
10. Install the 9V battery (included). To prevent damage to transmitter
,
remove the battery if not used for long periods (Fig. 10).
Operating Your Transmitter
Fig. 10
9
V
B
at
te
ry
!
CODE SWITCH
· CODE SWITCH: Codes are set by pushing dip switches up or down.
It is imperative that
the code used for both transmitter and receiver
is exactly the same; otherwise remote
controller will not work. Please
note the code switch will enable you to operate a second
remote
controller independently. For example, if you have two ceiling fans with
· Your remote control is ready for use after battery installation.
·
Restore power to ceiling fan and test for proper operation.
·
The fan remote control controls the fan setting:
HI: Turn on the fan at high speed.
MED: Turn on the fan at medium speed.
LOW: Turn on the fan at low speed.
LIGHT: ON/OFF: Press and release immediately to turn
DIMMER: Press and hold on to dim or brighten
lights to the desired level and release
(only for tungsten bulbs).
LIGHT
ON
/
OFF
HI
MED
DIMMER
FAN OFF
LOW
Fig. 11
/receiver. This will enable you to operate each ceiling fan independently.
