10
4
Installation of the
RADIO RECEIVER
and management of REMOTE CONTROL
to manage remote controls, the electronic circuit board must have a wireless module. the electronic circuit board can handle several types of code, the
fi rst remote control learned determines the type and, as a result, it is not possible to learn remote controls with codes that differ from that of the fi rst
remote control learned. The codes that can be handled are the 12 to 64 bit standards and, for rolling HCS© type codes, only the fi xed part but not the
rolling counter control. The fi rst transmitter learned determines the type of code that the receiver can handle; consequently the subsequent transmitters
learned must have the same type of code.
4.1 Installation of the RADIO RECEIVER
This operation deletes all codes present in the memory. There is no arrangement for deleting single codes.
The memory must be reset before learning the fIrst remote control so that there are no previously learned codes and no unused codes in the system.
The memory, and thus all the codes, can be deleted when the automation is closed.
1
Make sure that the
DIP5
in
OFF
position and the gate closed.
Keep pressed the button P in the control unit until the led INFO starts flashing
2
Release the button P and wait until the led INFO until the led is flashing regularly
Wait the reset of the memory
4.3
LEARNING OF THE REMOTE CONTROL
The memorization is possible when the gate is closet. Make sure that the
DIP5
in
OFF
position.
- If you push the button led INFO is lit on it means that the remote control is not compatible
- If you press the remote control and the led INFO flashes slowly , it means that the memory is full
- It is not possible to cancel a single code.
4.2
COMPLETE CANCELLATION OF THE MEMORY CODE
WARNING: Never install the module if the electronic circuit
board is powered.
WARNING: The module must be inserted in the correct direc-
tion
WARNING: If the module is removed after codes have been
learned, the code memory must be reset.
(See DELETING the MEMORY)
Elect. components
at the interior side
Connector on the circuit
1
The gate is closed
2
Press and release the Push Button, led INFO is lit on.
3
Press the button of the remote control for START the led INFO flashes for a while and then it lits on.
The code is memorized If you don’t need to associate any START command , wait led INFO is flashing
4
Press the button of the remote control for the PARTIAL OPENING.
Led INFO flashes for a while and the it lits on. the code has been memorized
If you don’t need to associate any command to the PARTIAL OPENING, wait until led INFO is flashing.
8 seconds
