PAGE 12
Setting AutoCity Speed
GPS Connected
GPS Error Message
GPS Lockouts
Mute Mode
settings.
1. Select AutoCity Mode by pressing the
VOL-/CITY button.
2. AutoCity Mode operates as follows:
• All radar alerts on X and K bands are
completely muted and only displayed
if the vehicle’s speed is lower than
the left speed setting (Low Speed
Mute). It does NOT mute Ka band and
Laser alerts.
• Radar detector operates in City mode
with reduced sensitivity as set in City
Mode Filter if vehicle’s speed is be-
tween left speed setting (Low Speed
Mute) and right speed setting (City
Mode Speed).
• Maximum detector sensitivity will be
achieved above right speed setting
(City Mode Speed). Radar detector
operated with maximum sensitivity on
all bands if vehicle’s speed is over the
right speed setting.
3. City Filter and City Mode Speed settings
are always default in Beginner Mode.
4. City Filter and City Mode Speed settings
can be changed in expert mode only.
1. Pressing the MUTE button during an
alert will temporarily mute the detected
signal and will automatically un-mute
20 seconds after the signal has passed,
or if a new or different signal has been
detected.
2. Pressing the MUTE button without an
alert will permanently mute the radar
detector on X and K bands until manually
unmuted or after a new startup cycle. Ka
band and laser alerts will NOT be muted
in this mode.
1. A GPS Connected message displays
along with a voice announcement when a
GPS signal is acquired after start-up.
2. You can disable the voice announcement
in the Menu (must be in Expert Mode).
1. A GPS Error message displays if the
radar does not receive a GPS signal for
30 seconds.
1. Mute audio alerts (voice/tone) for radar
within a 1,500 ft radius of the lockout
location.
2. Lockout display: When entering a lockout
location, “LOCKOUT” is shown in the
right hand corner of the display
3. POI alert operates only when GPS is
connected
4. Press and hold the mute button for 2
seconds to store or delete a lockout
location.
5. Select “Del ALL lockout?” in the menu to
delete all lockout locations in memory.
