Nolan N405 GT, Инструкции по безопасности и эксплуатации

Страница: 18 / 116

18 19
5.1. Open the visor completely (Fig. 7).
5.2. Push the release lever of the left side mechanism completely upwards moving it
over the side trim (Fig. 8) and pull the visor away from the helmet (Fig. 9).
5.3. Release the release lever and replace it downwards in its original position moving
it over side trim.
5.4. Follow the same steps on the right side of the helmet.
6. Visor Assembly
6.1. Place the left side of the visor on the corresponding side mechanism centring the
side hole of the visor on the mechanism itself (Fig. 9).
6.2. Push the release lever of the mechanism completely upwards moving it over the
side trim and press the visor against the side mechanism (Fig. 8, 9).
6.3. Disengage the release lever and replace it downwards in its original position
moving it over the side trim. Then check that the visor remains attached to the
mechanism by pulling it outwards.
6.4. Follow the same steps on the right side of the helmet.
6.5. If desired, replace the peak above the visor, and finally always replace both later-
al latches (see instructions above).
6.6. Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor
making sure that the mechanisms hold it in the different positions.
If necessary, repeat the above-mentioned steps.
- If the peak is assembled over the visor check the proper functioning as described
previously.
- Do not use the helmet if the visor and the lateral latches have not been assem-
bled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please refer to a Nolan
authorized dealer.
REMOVABLE PROTECTIVE CHIN GUARD
7. Removable Protective Chin Guard Release
7.1. Open the visor completely..
7.2. Pull the right and left chin guard release levers downwards and at the same time
remove the chin guard from the helmet by pulling it outwards (Fig. 10).
WARNING
Every time you wish to release the chin guard to use your helmet in the jet configura-
tion, insert the right and left chin guard locking slot covers (chin guard covers) in the
slots on the right and left side frames and push them towards the inside of the helmet
until you hear a fastening click (Fig. 11).
NOTE: The left and right chin guard covers are different from each other and are
marked on their back as “DX” (right) and “SX” (left).
8. Removable Protective Chin Guard Fastening
Before fastening the chin guard to the helmet, remove the chin guard covers by per-
forming the following operations:
8.1. Open the visor completely.
8.2. Remove the right and left chin guard covers by pulling them outwards (Fig. 11).