Nolan N40-5, Инструкции по безопасности и эксплуатации

Страница: 18 / 96

18 19
- We recommend using the VPS only and solely together with the approved stand-
ard visor, which has a transmittance value greater than 80%.
- The VPS does not replace the protection guaranteed by the visor.
- Always make sure that the VPS is clean and that it is operating properly in order
to avoid scratches and/or anomalous wear on it every time it is activated.
- As for VPS and visor maintenance and cleaning operations, please refer to the
appropriate section in the helmet user’s manual.
- The VPS scratch resistant/fog-resistant treatment highly reduces fogging. Pro-
tracted periods of adverse weather and/or environmental conditions might cause
fogging and/or formation of condensation on the VPS, which entails a reduction
of visibility and/or sharpness of vision: in this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the scratch resistant/fog-re-
sistant treated VPS quickly reduces sharpness of vision, thus causing scarce
visibility: in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temperatures
or heat sources. In this case, contaminations caused by contact with other mate-
rials might occur. These contaminations will cause marks and stains to develop.
In these cases (e.g. when the helmet is kept in the top case on hot days), it is
recommended to make sure the visor is not touching other materials.
9. VPS Disassembly
To remove the sun screen from the helmet, open the visor completely and lower the
VPS by rotating the side slider completely upwards (Fig. 11B).
Hold the left lateral part of the sun screen and pull it toward the outside of the helmet
(Fig. 12).
Repeat the same operation on the right side of the helmet.
10. VPS Assembly
To assemble the sun screen on the helmet, open the visor completely and push the
side slider completely upwards (Fig. 11B).
Insert the sun screen left end into the left side guide until the grip pawl is hooked in
shell housing (Fig. 12).
Repeat the same operation on the right side of the helmet.
WARNING
- Make sure the VPS operates correctly by moving the left side slider towards
the bottom (Fig. 11A) and the top side of the helmet (Fig. 11B) until you hear
the clicks meaning that it enters the relative positions. If necessary, repeat the
above-mentioned steps.
- If the VPS opening/closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolan authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
11. Inner Comfort Padding Disassembly
11.1. Open the chin strap (see specific instructions), pull the front of the left cheek pad
towards the inside of the helmet to undo the snap fasteners from the left side
frame (Fig. 13). Repeat the same operation on the right side of the helmet.