Nolan N40-5, Инструкции по безопасности и эксплуатации

Страница: 16 / 96

16 17
6. Visor Assembly
6.1. Place the left side of the visor on the corresponding side mechanism centring the
side hole of the visor on the mechanism itself (Fig. 9).
6.2. Push the release lever of the mechanism completely upwards moving it over the
side trim and press the visor against the side mechanism (Fig. 8, 9).
6.3. Disengage the release lever and replace it downwards in its original position
moving it over the side trim. Then check that the visor remains attached to the
mechanism by pulling it outwards.
6.4. Follow the same steps on the right side of the helmet.
6.5. If desired, replace the peak above the visor, and finally always replace both later-
al latches (see instructions above).
6.6. Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor
making sure that the mechanisms hold it in the different positions.
If necessary, repeat the above-mentioned steps.
- If the peak is assembled over the visor check the proper functioning as described
previously.
- Do not use the helmet if the visor and the lateral latches have not been assem-
bled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please refer to a Nolan
authorized dealer.
SIDE PLATES
When the helmet N40
5
is configured without the visor the side plates must be assem-
bled in its place.
7. Side Plates Assembly
To assemble the side plates first remove the lateral latches and (if assembled) the
peak and the visor (see instructions above).
7.1. Place the left side plate on the corresponding side mechanism centring its hole
on the mechanism and its teeth (Fig. 10).
7.2. If you wish to assemble the peak above the plates see the relevant installation
instructions.
7.3. Assemble the left lateral latch as indicated in the instructions above.
7.4. Follow the same steps on the right side of the helmet.
8. Side Plates Disassembly
To disassemble the side plates first remove the lateral latches and (if assembled) the
peak (see instructions above).
Then remove the plates from the side mechanisms.
Next, reassemble the visor and then the peak (if any) as explained in the previous
instructions.
WARNING
- When using the helmet in a configuration without the visor, always assemble the
lateral latches and the side plates.
- Do not use the helmet if the plates and the lateral latches have not been assem-
bled properly.