9
•
Connect the battery to the wiring system (Fig. 8).
•
Switch on the N-Com system (press “ON” for about 2 seconds) to verity its proper operation.
N.B. If the system does not work, remove the flex and repeat the previous operation, making sure that the
“n” is positioned as in Fig. 6.
Fig. 6
Fig. 7
Fig. 8
•
Secure the keypad flex in the specials stop (Fig. 9).
•
Position the e-box in its seat, arranging the keypad flex cable so that it does not interfere with the
positioning of the e-box, as illustrated in figures 10-11-12.
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
•
Position the left loudspeaker in
its seat, inserting the cable in
the
special
groove.
If
necessary,
secure
the
earphone using the adhesive
supplied
as
standard
equipment (Fig. 13).
3.3
Microphone positioning
ONLY FOR X-1005 HELMETS
•
With the help of the flat head tool supplied as standard equipment, open the microphone-holder clip
located on the right side of the helmet (Fig. 14-15).
•
Position the microphone at the desired length, sliding the excess portion inside the cheek pad lining (Fig.
16).
N.B.: To ensure good voice transmission quality, it is recommended to adjust the length of the microphone
so that the foam part is in front of your mouth.
•
Close the clip. Make sure that the microphone side with the letter “n” is facing the inside of the helmet (Fig.
17).
