Nokia IP710 Series, Руководство по установке

Страница: 135 / 182

IP700 Series Installation Guide 135
Login Prompt Appears, But Password Not Accepted
Login Prompt Appears, But Password Not Accepted
Cause Entered wrong password.
Solution Obtain a valid password or set the password to a default value.
Setting the Password to a Default Value
You must have local serial console access to your appliance to perform
the following procedure. With a keyboard and monitor directly connected
to the appliance, the boot prompt does not appear, and you cannot perform
this procedure.
1.
Boot up in single-user mode by rebooting or power cycling the
appliance. When the boot prompt appears, enter
-s
before the
appliance goes into multiuser mode. You have about 10 seconds to do
this.
2.
After the appliance boots up, the following text appears:
Enter pathname of shell or RETURN for sh:
Press the Enter key.
3.
Type
/etc/overpw
at the
#
prompt. When the response asks if
you want continue, type
y
.
4.
The admin password defaults to no password for admin. Continue to
boot to multiuser mode.
5.
Reconfigure the password as you normally would in Lynx.
NOTE:
If you are defaulting the password with IPSO 3.4 or later, blank
passwords are not accepted in Voyager or Lynx. In such cases, enter the
following command to use a blank password to reset the password from
the command line:
dbpasswd admin newpassword ""
The two double quotation marks at the end of the command indicate a
blank password.
After executing this command, the system reports that the password was
not successfully changed. In fact, the password was changed and is now
newpassword
.
All manuals and user guides at all-guides.com