Nokia IP200 Series, Руководство по установке, Страница: 74 / 100

7
Using the Nokia IPSO Boot Manager
74 Nokia IP200 Series Security Platform Installation Guide
dd if=/image/current/bootmgr/<boot_manager_file>
of=/dev/[rwd0 | rwd1]
where < boot_manager_file > is the name of the boot manager file on your
system. For example, the boot manager file for IPSO 4.0 is nkipflash-
4.0.bin, for IPSO 3.9 it is nkipflash-3.9.bin, and so on.
Note
In this command, use rwd1, as the boot manager resides on wd1 in
multi-user mode.
You can also use the command
ipsctl kern:bootmgr:bmdev
to
determine the boot manager device.
3.
If you wish to establish a boot manager password again, follow the
procedure under
“To set or change the boot manager password” on
page 73.
If you have lost both the admin password and the boot manager password and
your appliance is disk-based, you can reset the boot manager password, using
the following alternative procedure.
To reset the boot manager password on a disk-based appliance
1.
Turn off the power to the appliance.
2.
Remove the hard-disk drive from the appliance.
3.
Turn on the power to the appliance.
4. When the appliance reboots, enter the boot manager.
5.
At the boot manager command prompt, type
passwd
.
The New Password prompt appears.
6.
Enter your new password.
7. Turn off the power to the appliance.
8. Reinstall the hard-disk drive.
9.
Turn on the power to the appliance.