Nogueira PN-MASTER 3000, Инструкция по эксплуатации

Страница: 18 / 56

18
Instructions manual
This adjustment must be done after the
sharpen or new knifes installation.
a) Remove the feeding chute (1) loosing the pin
(2).
b) Loosen (but don’t remove) the impeller
fastening bolts (3).
c) Displace the impeller (4) manually forward,
approximating the knifes (5) nearest as possible
against the counter knife (6).
IMPORTANT: It cannot have interference
between the knives and counter-knife during the
operation. Therefore, Nogueira recommends a
minimum gap
0,05 to 0,15 mm.
d) Check the gap through feeding nozzle (7),
turning the impeller (4) manually and slowly.
e) After the adjustment, tighten the bolts (3) to
fasten the impeller (4) on correct position.
f) Reinstall the chute (1) and close the impeller
compartment cover.
2
8
1
3
7
6
4
5
Gap adjustments between knife and counter knife